EN8D Bright Bars
A medium-carbon steel grade to discuss for engineering and machined-component requirements.

Representative material photograph, not grade-specific. Replace with approved product photography.
EN8D: material overview
EN8D is a medium-carbon designation used in engineering procurement. Its response in a component depends on section size, supplied condition and any subsequent heat treatment. Bright appearance is not evidence of a particular strength or hardness.
What to specify at enquiry
For EN8D bright bars, state the drawing specification, final part duty and whether machining is followed by heat treatment. If a strength or hardness range is required, include it explicitly in the enquiry rather than relying on the grade label.
Application considerations
Engineering shafts, pins and machined components only where the design specification calls for EN8D. Application suitability needs engineering review.
Manufactured or supplied?
Bright bar manufacturing is a company activity; the in-house or sourced supply route for EN8D, its dimensions and condition must be confirmed individually. Black bars and coils are supplied rather than described as manufactured in-house.
Before you specify
Draft technical overview. Company approval required for current availability, supply route, applicable standards and all technical values.
Product forms
Bright bars by enquiry. Rounds, hexagons, squares, flats and profiles are subject to grade-specific confirmation; black bars and coils are supplied where available.
Sizes, lengths & tolerances
5 mm to 250 mm
Supply condition
Black Bar/Coil, Bright Hexagon, Bright/Ground Bars
Material standard
COMPANY TO CONFIRM — governing material standard, edition and any customer-specific requirements. No equivalence to a different designation is implied.
Alternative spellings, not equivalences
EN 8D (spacing only)
Inspection & documentation
COMPANY TO CONFIRM — available material test reports, heat traceability, test methods, sampling and reporting scope for this grade and order.
Chemical composition
Element | Minimum (%) | Maximum (%) |
|---|---|---|
Carbon (C) | 0.400 | 0.450 |
Manganese (Mn) | 0.700 | 0.900 |
Silicon (Si) | 0.150 | 0.350 |
Sulphur (S) | - | 0.035 |
Phosphorus (P) | - | 0.035 |
Mechanical properties
NOT YET APPROVED — insert verified EN8D mechanical-property requirements with the relevant size and delivery condition. No property values are implied.
Continue your material review.
Related reading, not equivalent grades. Any substitution requires an approved specification review.